Free Energy Developer's Forum

Hi,

I have finally build my first SSG and kindly i ask you to give me some views ... whats going on here.

With the 2n3055 and all the mentioned bedini ssg circuit the coil is made of bifilar awg 22 and awg 26 with a 700 turns. The rotor is made of a Video Head with 4 earth magnets if 12mm round. I have tested also the 90 V neon bulb which works ok when charging battery will be disconnected.

Running my bedini SSG with batteries.

Power Battery 12.40 volts 7 amps and the charging Battery Optima deep cycle yellow top voltage at that time was 12.073.
With the pot fully counter clockwise to take the maximum speed on the bedini I had 2232 RPM while claiming 200 ma from the power battery.
I could see the charging battery getting charged as the voltage start going up. I only did this test for 2 hours or so and the charging voltage now is 12.270.. " so it looks like its charging"

Now my test with the 1 OHM RESISTOR instead of the charging Battery.

With all the same settings on the pot I removed the charging battery and replaced it with 1 ohm (1 watt) resistor and measured the voltage across the resistor... which gave me only .1870 so its under 2 mv the speed reads 1075 RPM. If i turn the pot clockwise a bit i noticed the charging voltage to rise.

Can someone kindly help me and give me some views how is my project doing ?? Is it charging well or low? what is your opinion or what should i expect ?

Many thanks for your help and views plus time. Your feedback will be much appreciated.

Regards

Ray

Hi Firetank,

Great that you've got it running. But I have the same problem as you, I do not know yet what to expect and whether by motor is working well, except that I don't seem to have overunity.

I'm a newbie myself, so I can't help you. Hope someone else can help us explaining what to expect and what a realistic goal is. Should we be able to achieve overunity easily and soon ?

For now, I think you just have to go on and replace batteries a lot and see whether it is charged better than it consumes...

Good luck.

Ben

I have been reading a lot about bedini tech, and am interesting building and making it work.
I just joined a few seconds ago,a dnwill be reading more.

Thanks for all for all you have posted, and I have watching many of the clips available.
best 2 all
acm

Hi Ray,

Glad to hear your SG running...

I think the next step you need to calculate the COP. Most people report the COP will increase every cycle of Charge/Discharge.

With your 1 Ohm Resistor test I'm sure your result are good.

In my own setup I only get average 0.75 of COP, maybe I use not brand new Battery, but really this device can reconditioning death battery ( I have more than 5 Battery back to live using my SG). So far this is the benefit we can see on SG and of course we can learning about the technology.

Cheers
Selamatg