Free Energy Developer's Forum

Hi a small question here regarding the 1K pot....

In the pot there are 3 connections and in the diagram by seph shows that one end is connected to the resistor and the other end to one of the coil wire. This means leaving the middle connection of the pot empty.

When you vary the pot from one side to the other there will be no difference in resistance but if you connect one end to the first one and the other end to the coil to the middle one (leaving) the 3rd connection empty i can see the resistance vary.

Question is:- Am I doing right or wrong?

Thanks
Firetank

Firetank wrote:Hi a small question here regarding the 1K pot....

In the pot there are 3 connections and in the diagram by seph shows that one end is connected to the resistor and the other end to one of the coil wire. This means leaving the middle connection of the pot empty.

When you vary the pot from one side to the other there will be no difference in resistance but if you connect one end to the first one and the other end to the coil to the middle one (leaving) the 3rd connection empty i can see the resistance vary.

Question is:- Am I doing right or wrong?

Thanks
Firetank

always use the center if u want a pot else it wil just be a resistor.
center and the one left OR the one right.
cheers.

[/quote]


always use the center if u want a pot else it wil just be a resistor.
center and the one left OR the one right.
cheers.[/quote]



Hi, and thanks for the reply.....

This will put my mind in rest

Cheers